Page Issue - Magni Gyro M16C Ordinary Maintenance Manual

M16 (C) TANDEM TRAINER
MAINTENANCE MANUAL
The instrument panel should be dusted with a soft clean paintbrush. Any dirty instrument dial should be wiped
with a soft dry cloth.
The use of a pressure washer or of strong jets of water is strongly not recommended. Their use may result in
damage to instruments, engine or electrical systems. There is also a danger that the use of these systems could
wash away protective grease from bearings and controls.
When stored in a hanger or outside, it is recommended to cover the gyroplane with a snug fitting, non marking
cover.
The use of an adequate cover supplied by Magni Gyro is strongly recommended. This cover is produced with
ventile materials to allow the evaporation of humidity that can occur when the cover touches the gyroplane's
surface.
Before covering the gyroplane, ensure that all the surfaces are dried up well, so as to avoid blistering on painted
surfaces.
Blades must be blocked longitudinally using the rotor brake. It is strongly advised not to tie blades, except in case
of very strong wind. In this case, use the adequate tip protection so as to avoid undue loads on the blades.
PAGE ISSUE
88
A_November 2012