M16 (C) TANDEM TRAINER
MAINTENANCE MANUAL
3.10.4.4
CABLE TENSION TABLE
Cable specifications ‐ galvanized steel 3,2 mm x 49 wires
Cable tension allowance
3.10.5
INSPECTION OF RUDDER PEDALS RODS
(See Fig. 3.10/5)
The inspection of the pedal rods pn 076 and pn 078 is limited to checking the freedom of movement of the joints
(1) when they are at the end of their travel, the absence of abrasion or unexpected bending, as well as the correct
tightening of the locking bolts (M5x42, M6x55, M6x25, M6x80) on the pedals.
Incorrect tightening may generate play and vibrations on the pedals pn 071 and pn 072 and consequently on the
nose wheel (3) (buffeting).
3.10.6
INSPECTION OF PEDALS
(See Fig. 3.10/5)
1.
Check the correct movement of the pedals pn 071 and 072 until they reach the stoppers;
2.
Verify that the pedals have no lateral play;
3.
If there is some lateral play, tighten the locking bolts pn M5x42 on which the movements of the pedals
are articulated;
4.
Verify that the safety wiring (2) is still there and check the correct positioning of the turnbuckles pn
MS21251‐B3S on the rear pedals.
ISSUE
A_November 2012
.
from
180 N (40 lbs)
to
270 N (60 lbs)
PAGE
65