Reading Of Spare Parts Pn (Part Number - Magni Gyro M16C Ordinary Maintenance Manual

1.6.2 READING OF SPARE PARTS pn (PART NUMBER)
All the components of a Magni Gyro gyroplane are identified with a part number. Users and maintenance staff can
use this part number as a reference when requiring information or spare parts. These pn are also used in the
handbooks when describing procedures or controls. They are listed in the Spare Parts Catalogues supplied with
each gyroplane.
The following notes explain how to read a part number: part numbers are composed of 7 digits, the meaning of
which is as follows:
XXX‐XX‐XX
XXX the first 3 digits are the progressive number given by the company to the part.
This number is then combined with two other groups of numbers:
XX indicates the number of the page where the part is described in the Spare Parts Catalogue.
XX indicates the model of the gyroplane where the part is installed, and by consequence the Spare Parts
Catalogue it refers to.
NOTE:
The same part number XXX may be associated with several page numbers or model identifiers,
which is due to the repeated use of the same part in different groups and models. In this manual the
parts are identified only through the first 3 digits of the pn, the other 4 digits are complementary.
Example of part number reading pn 267‐09‐16
This identifies part number 267, appearing in page 09 of the spare parts catalogue of the M16 (M16C) gyroplane
model.
1.6.3 REQUEST FOR INTERVENTION TECHNICAL ASSISTANCE
NOTE:
All maintenance, repair, etc. must be carried out only by SPECIALISED PERSONNEL; otherwise, call our
TECHNICAL ASSISTANCE DEPARTMENT.
Magni Gyro has set up for its customers the TECHNICAL ASSISTANCE DEPARTMENT so as to solve any
problem connected to the machine's operation and maintenance.
EXCEPTION
Magni Gyro does not guarantee repair work and does not answer for the ensuing damages when the
above‐mentioned repairs have not been performed by its own personnel.
Assistance must be requested after an accurate analysis of the problems and of their causes.
The requests must always be in writing and the following information must be specified in the message:
PAGE
16
•
Machine model;
•
Serial number;
•
Detailed description of the detected defects;
•
Checks performed;
•
Adjustments and regulations carried out and their effect;
M16 (C) TANDEM TRAINER
MAINTENANCE MANUAL
ISSUE
A_November 2012