Table Inserts - Shop fox W1807 Owner's Manual

Model W1807 7 ⁄ HP Heavy-Duty Industrial Tilting Spindle Shaper
1
2
5. Pull the tensioning bar forward, and maintain the
pressure on the V-belt as you tighten the locking
handle.
Note: The V-belt is properly tensioned when there
is about ⁄ " deflection in the middle of the pulleys
1
4
with moderate pressure (see Figure 24).
6. Spin the pulleys to make sure the V-belt is tracking
properly.
7. Close and secure the motor access door.

Table Inserts

The Model W1807 features three table inserts: 2
5 ⁄ ", and 9 ⁄ " I.D. To safely support the workpiece dur-
7 7
8 8
ing shaping, use these three inserts to keep the opening
around the cutter as small as possible while not interfer-
ing with the cutter rotation.
Note: Refer to Table Insert Adjustment on Page 42 for
additional information.
NOTICE
When tilting the spindle, make sure the cutter is clear
of the table inserts and fence boards. Otherwise,
severe damage to the cutter and shaper may result.
����������
Figure 24. Testing for correct V-belt
⁄ ",
3
4
Figure 25. Table inserts installed.
-27-
������
������
tension.