Ember Placement - Heat & Glo 6000CLX-IFT-S Installation Manual

G. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT completely block burner
ports with ember material. Replace ember material an-
nually. Improperly placed embers interfere with proper
burner operation.
Ember material is shipped with this gas appliance. To
place the ember material:
• Embers CANNOT completely block burner ports. Care
should be taken not to block the lighting trail of ports.
• Embers may only be placed in areas as shown in
Figure 11.3.
• LP Only: Using dime-size pieces of Glowing Embers®,
overlap the burner ports as shown in Figure 11.4. The
impingement created by the embers will help blend the
fire.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
EMBERS
Figure 11.3 Placement of Embers
Figure 11.4 Embers Overlapping Burner Port Holes (LP only).
60
NO EMBERS IN SHADED AREA
Heat & Glo • 6000CLX-IFT, 8000CLX-IFT Installation Manual • 2506-980 Rev. B • 3/18