Renesas M32182T2-PTC Instruction Manual page 7

Converter for in-circuit connection

Enlarged version

5.3 For Board-mounted Evaluation

(1) Mount the NQPACK144SD.

(2) Mount the M32182F3xFP on the NQPACK144SD.

(3) Mount the HQPACK144SD on the NQPACK144SD.

6. Selecting a Clock

With the M32182T2-PTC, it is possible to select a clock

supply to the MCU by the clock select switch (SW1). Select

a clock supply as shown below.

However, when used with the M32182T2-PTC, the clock

cannot be supplied from the target system.

10 MHz: Supplies the clock (X1: 10 MHz) on the M32182T2-

PTC board to the MCU.

SOCKET: Supplies the clock to the MCU from the socket

(X2) for mounting the oscillator on the

M32182T2-PTC board. By mounting the oscilla-

tor to the X2 socket of the MCU, it is possible to

change the operating frequency.

For more details on the connecting the X2 socket

and the MCU, see Figure 5 (right).

Connection for board-mounted evaluation

: Position of No. 1 pin

Be sure to match the position of No. 1 pin of the foot pattern

and each part.

Figure 4 Connection for board-mounted evaluation

Figure 5 Connection diagram of X2 socket

( 5 / 7 )

Mount an oscillator to X2 as

shown in the diagram printed on

the board.

Connected to XIN pin of MCU

Connected to XOUT pin of MCU

R9:

1M Ω

R7:

510 Ω

C20: 27 pF

C22: 27 pF

Table of Contents