Auto; Run/Stop; Single - Rigol MSO4000 Series Quick Manual

Digital oscilloscope

Hide thumbs Also See for MSO4000 Series:

Table of Contents

RIGOL

AUTO

Press this key to enable the waveform auto setting function. The

oscilloscope will automatically adjust the vertical scale, horizontal

time base and trigger mode according to the input signal to realize

optimum waveform display. Besides, quick parameter measurement

function is also provided.

Note that auto setting requires that the frequency of the signal under test should be

no lower than 50 Hz, the duty cycle be greater than 1% and the amplitude be at

least 20 mVpp. If the parameters exceed theses limits, "Auto failed" would be

displayed after pressing this key and the quick parameter measurement menu

might not be displayed.

Press this key to set the state of the oscilloscope to "Run" or "Stop".

In "Run" state, the key is illuminated in yellow and red in "Stop"

state.

Press this key to set the trigger mode to "Single". In single trigger

mode, the oscilloscope triggers when the trigger condition is met

and then stops.

MSO4000/DS4000 Quick Guide

Table of Contents

Ds4000 series