Miele WTZH 730 WPM Operating Instructions Manual page 86

Problem solving guide
General problems with the washer-dryer
Problem
Fabric softener is not
completely dispensed
or too much water
remains in the 
compartment.
At the end of the
programme there is still
liquid in the capsule.
The display is in a
different language.
The display is dark.
The programme
duration remaining that
is shown in the display
fluctuates.
When the drum is
empty a load appears in
the display, or when the
drum is full the load is
displayed as <25%.
86
Possible cause and remedy
The siphon tube is not correctly positioned or
clogged.
 Clean the siphon (see "Cleaning and care -
Cleaning the detergent dispensing drawer").
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
 Clean the small pipe.
This is not a fault. For technical reasons a small
amount of water will remain in the capsule.
A different language has been selected in "Settings -
Language ".
 Set the language you want.
The flag symbol serves as a guide.
The display has switched off automatically to save
energy (Standby mode).
 Press any button. This switches Standby off.
The countdown time adapts constantly to the current
washing and drying situation.
When the washer-dryer was switched on, there was
already laundry in the drum. This has shifted the zero
point of the load sensor.
 Empty the drum and switch the washer-dryer off
and back on again.