The highest position of the feed dog should be between 0.80 and 0.90 mm from the surface of the needle
plate.
1. Remove the free-arm cover.
2. Lower the presser foot and turn the power switch on.
3. Turn the handwheel toward you to set the feed dog at the highest position.
4. Loosen the setscrew (A) and nut.
5. Adjust the feed dog height by turning the adjusting screw. The highest position of the feed dog should
be between 0.80 and 0.90 from the surface of the needle plate.
6. Tighten the nut and setscrew (A) .
7. Attach the free-arm cover.
Presser foot
Feed dog
Setscrew (A)
Feed Dog Height
0.80 – 0.90mm
Surface of the needle plate
Setscrew (A)
13
Higher
Adjusting screw
Nut
Lower