Replacing The Circuit Board A - Janome DC6030 Service Manual

To remove:
1. Remove the front cover.
2. Pull out connectors from the circuit board-A.
3. Remove the setscrews (6pcs.) and the circuit board-A.
Note:
Do not disconnect the connectors by pulling on cord.
To disconnect, grasp the connector, not the cord.
To attach:
1. Follow the above procedures in reverse.
(Attach the flame retardant insulation paper 1 and 2).
Note:
1. Make sure to insert the connector into the connector receptacle of the same color on the board.
2. Make sure to insert the connector in the correct direction pushing to snap it in place.
Cirucit board A

Replacing the Circuit Board A

Setscrew
Setscrew
Setscrew
Setscrew
Cirucit board F, F2 and L2 connector
Setscrew
Setscrew
Flame retardant
insulation paper 2
23
Flame retardant
insulation paper 1