Adjusting Feed Dog Height - Janome Jubilee 60507 Service Manual

Adjusting Feed Dog Height

• The distance between the lowered presser foot and needle plate should be 0.75 to 0.85 mm
when the feed dog is in its highest position.
<To adjust>
Select the straight stitch ( ) and set the stitch width at "4".
Lower the presser foot. Turn the handwheel to bring the feed dog to its highest position.
Remove the base cover (see page 5).
Loosen the setscrew (A) and nut.
Turn the adjusting screw to set the feed dog height to 0.75 to 0.85 mm.
Tighten the nut and setscrew (A).
Attach the base cover.
0.75 to 0.85mm
Needle plate
Feed dog
To raise
To lower
Setscrew (A)
Nut
Adjusting screw
16