Circuit Board A Connection - Janome DC6030 Service Manual

Insert all the connectors according to the diagram shown below.
Note:
Do not disconnect the connectors by pulling on cord.
To disconnect, grasp the connector, not the cord.
Note:
1. Make sure to insert the connector into the connector receptacle of the same color on the board.
2. Make sure to insert the connector in the correct direction pushing to snap it in place.
Bobbin winding switch (Blue)
Printed circuit board P (Black)
Printed circuit board A
Power switch (White)
DC motor (White)

Circuit Board A connection

Printed circuit board A connecting diagram
Program (Red) (Not used)
Controller (Black)
Presser foot lifter switch (Green)
Buttonhole sensor program (Red)
Printed circuit board L2 (White)
Printed circuit board L2 (Bkue)
Printed circuit board F2 (White)
Printed circuit board F (White)
Speed control slider (White)
Zigzag width motor (Green)
Solenoid (Black)
Thread cutter motor (White)
Feed motor (White)
16