Needle Drop Position - Janome DC6030 Service Manual

Set the stitch pattern to "
Select zigzag stitch "
The clearance between the needle and the edge of the needle hole in the needle plate should be at least
0.2 mm on either side. If not, adjust as follows:
1. Turn the power switch on. Set the stitch pattern to "
Check that the needle drop position.
2. If the needle drop position is not correct, turn the power switch off and remove the face cover.
Loosen the hexagonal socket screw 3 x 4. Adjust the needle drop position by turning the eccentric pin.
Note:
Make sure to adjust the eccentric pin between the range of downward direction.
3. Tighten the socket screw 3 x4.
Attach the face cover.
Note:
Check the hook timing after this adjustment.
Socket screw 3 x 4

Needle Drop Position

". The standard needle drop position should be at center of the needle plate hole.
", and set the stitch width at "5.0".
Eccentric pin
Rotation center
Between the range of
Eccentric
downward direction
", and select zigzag stitch "
Needle hole
0.2 mm or more
A
9
".
0.2 mm or more
B
A=B