Table of Contents
Advertisement
MECHANICAL ADJUSTMENT
FEED DOG HEIGHT
The highest position of the feed dog should be between 0.80 to 0.90 mm from the surface of the needle plate.
1. Lower the presser foot and turn the power switch on.
2. Turn the handwheel toward you to set the feed dog at the highest position.
3. Remove the free arm cover.
4. Loosen the setscrew q and nut w.
5. Adjust the feed dog height by turning the adjusting screw e. The highest position of the feed dog should be
between 0.80 to 0.90 from the surface of the needle plate.
6. Tighten the nut w and setscrew q.
7. Attach the free arm cover.
Presser foot
0.80 to 0.90 mm
Feed dog
Surface of the needle plate
q
A
B
e
w
q
14
Advertisement
Table of Contents
