Front Cover
To remove:
1. Remove the face cover.
2. Remove the setscrews (A) (2 pcs.).
3. Loosen the setscrew (B) (1 pcs.).
4. Remove the setscrews (C) (1 pcs.), setscrews (D) (4 pcs.),and back cover.
(Disconnect the connectors)
5. Remove the setscrews (E) (2 pcs.).
6. Remove the front-cover (Reference P.6), disconnect all the connectors from the circuit board A.
Notes:
Do not disconnect the connectors by pulling on cord.
To disconnect, grasp the connector, not the cord.
To attach:
1. Follow the above procedures in reverse.
Notes:
1. Make sure to insert the connector into the connector receptacle of the same color on the board.
2. Make sure to insert the connector in the correct direction pushing to snap it in place.
Changing External Parts (3-1)
Setscrews (A)
Back cover
Setscrews (B)
Setscrews (E)
Setscrews (D)
Setscrews (C)
Setscrews (D)
5
Setscrews (D)
Setscrews (D)
Setscrews (E)