Message Codes - Leica DISTO X4 Instruction Manual

Message Codes

Me s s a g e Co d e s
No. Cause
156 Transverse tilt greater than 10°
162 Calibration error
204 Calculation error
240 Data transfer error
252 Temperature too high
253 Temperature too low
255 Received signal too weak, measuring time too long
256 Received signal too high
257 Too much background light
260 Laser beam interrupted
301 Device was moved, levelling not valid anymore
303 Error with Leica DST 360 adapter
* If other message codes are displayed frequently even the instrument has been switched off and on, please contact your dealer.
Leica DISTO™ X4
Correction
Hold the instrument without any transverse tilt.
Make sure the device is placed on an absolutely horizontal and flat
Perform measurement again.
Connect device and repeat procedure
Let device cool down.
Warm device up.
Change target surface (e.g. white paper).
Change target surface (e.g. white paper) .
Shadow target area.
Repeat measurement.
Perform levelling again. Measuring with invalid levelling is partially
Repeat measurement.
53