Connector Board - HP Stream x360 Maintenance And Service Manual

Connector board

NOTE: The connector board spare part kit does not include the connector board cable. See
cable on page 55
spare part number 906784-001.
Description
Connector board (includes volume button actuators, audio combo jack, and USB 2.0 port)
Before removing the connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the connector board:
1. Release the ZIF connector (1) to which the connector board cable is attached, and then disconnect
the connector board cable from the system board.
2. Remove the Phillips PM2.0×3.3 screw (2) that secures the connector board to the keyboard/top cover.
3. Remove the connector board (3).
Reverse this procedure to install the connector board.
56 Chapter 5 Removal and replacement procedures
for connector board cable removal instructions. The connector board cable is available using
Bottom cover on page
Battery on page
28).
30).
Connector board
Spare part number
906783-001