Solid-State Drive And Hardware - HP Stream x360 Maintenance And Service Manual

Solid-state drive and hardware

Description
128-GB, SATA-3, TLC
128-GB, SATA-3
Solid-state drive hardware kit (includes bracket, cable, Mylar, and screws)
Solid-state drive board
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×3.0 screw (1), and then pull the solid-state drive module from the socket (2).
2. If you need to remove solid-state drive board, lift the system board ZIF connector (1) and disconnect the
cable (2).
Bottom cover on page 28).
Battery on page 30).
Component replacement procedures
Spare part number
L17297-001
918858-001
918701-001
918702-001
35