Cisco 890 Series Installation Manual page 18

Chapter 4 Initial Configuration
Please change these publicly known initial credentials using Cisco CP Express or the Cisco
IOS CLI.
Here are the Cisco IOS commands.
username <myuser>
no username username1
Replace <myuser> and <mypassword> with the username and password you want to use.
For more information about Cisco CP please follow the instructions in the QUICK START
GUIDE for your router...
...
User Access Verification
Username:
Step 3 Enter the username username1, and press Return or Enter. The following prompt is displayed:
Password:
Step 4 Enter the password password1, and press Return or Enter. The following prompt is displayed:
Router#
A message is displayed that is similar to the first warning message. The message directs you to change
the username and password.
You are now in privileged EXEC mode.
Note
Step 5 Enter configuration mode using the following commands.
Router#
Router#config t
Router(config)#
Router(config)#username username privilege 15 secret 0 password
To change the username and password, enter the following at the prompt:
Step 6
username username privilege 15 secret 0 password
The username and password are the username and password that you determine.
To continue using the Cisco IOS CLI for initial configuration, see the applicable configuration
procedures in
Software Configuration
Note
Verify the initial configuration. See the
Step 7
OL-23125-02
privilege 15 secret 0 <mypassword>
You must change the username and password before you log off the router. You cannot use the
username username1 or password password1 after you log off from this session.
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers
Guide.
Save your configuration changes regularly to avoid losing them during resets, power cycles, or
power outages. Use the copy running-config startup-config command at the privileged EXEC
mode prompt (Router#) to save the configuration to NVRAM.
"Verifying the Initial Configuration" section on page
Cisco Integrated Services Router Hardware Installation Guide
Cisco 860, 880, 890 Series
4-2.
4-3