Connecting A Voice Isdn Bri Line - Cisco 890 Series Installation Manual

Cisco 860, 880, 890 Series
This option allows a stepped offhook resistance during seizure, which avoids overloading the circuit
during offhook in the event that ringing voltage is present on the circuit at the same time as the trunk
seizure. The stepped offhook resistance is initially set to 800 Ohms, then adjusts to 50 Ohms when
ringing voltage is not present.
To enable the soft-offhook command on the port, and to access the connection command with plar opx
syntax, see the

Connecting a Voice ISDN BRI Line

Use a straight-through RJ-45 cable to connect the voice BRI port to the ISDN network through a
telephone outlet or other device.
To prevent damage to the router, be sure to connect the BRI cable to the BRI connector only and not to
Caution
any other RJ-45 connector.
To connect the voice BRI line, follow these steps:
Step 1 Connect one end of a straight-through RJ-45–to–RJ-45 cable to the Voice BRI port.
Note
Cisco Integrated Services Router Hardware Installation Guide
3-42
Cisco Command Lookup
When the interface is configured as NT and is connecting to a TE device, use a crossover cable.
See Table A-27.
Tool.
Chapter 3 Connecting the Router
OL-23125-02