Table Of Contents - Graco 248171 Instructions Manual

Table of Contents

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Husky 515 and Husky 716 Pump Matrix . . . . . . . 22
Husky 515 and Husky 716 Repair Kits . . . . . . . . . 22
Husky 515 and Husky 716 Common Parts . . . . . 24
Husky 716 Parts Drawing . . . . . . . . . . . . . . . . . . . 27
Torque Sequence . . . . . . . . . . . . . . . . . . . . . . . . . 29
Husky 515 Technical Data . . . . . . . . . . . . . . . . . . 30
Husky 515 Dimensions . . . . . . . . . . . . . . . . . . . . . 31
Husky 716 Technical Data . . . . . . . . . . . . . . . . . . 32
Husky 716 Dimensions . . . . . . . . . . . . . . . . . . . . . 33
Husky 515 and 716 Performance Charts . . . . . . . 34
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
•
This equipment is for professional use only.
•
Read all instruction manuals, tags, and labels before operating the equipment.
•
Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor.
•
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
•
Check equipment daily. Repair or replace worn or damaged parts immediately.
•
Do not exceed the maximum working pressure of the lowest rated component in your system. This
equipment has a 100 psi (0.7 MPa, 7 bar) maximum working pressure at 100 psi (0.7 MPa, 7
bar) maximum incoming air pressure.
•
Use fluids and solvents that are compatible with the equipment wetted parts. Refer to the Technical
Data section of all equipment manuals. Read the fluid and solvent manufacturer's warnings.
•
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 82°C (180°F) or below -40°C (-40°F).
•
Wear hearing protection when operating this equipment.
•
Do not lift pressurized equipment.
•
Do not kink or overbend hoses or use hoses to pull equipment.
•
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
•
Do not use 1.1.1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or
fluids containing such solvents in pressurized aluminum equipment. Such use could result in a
chemical reaction, with the possibility of explosion.
2 308981
Symbols
Warning Symbol
This symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
This symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
WARNING
WARNING
CAUTION