Rear Panel Functions; Dip Switch Functions - Seco DS9000 Installation & Operation Manual

UP
DOWN
VALUE/CODE
HI/LOW
LED DISPLAYS:
HI ADJ LED
LOW ADJ LED
TACH LED
REFERENCE LED
NOTE: The TACH and REFERENCE LED are only used while the Start input is on.
1.7

REAR PANEL FUNCTIONS

The rear panel of the DS9000 contains 3 terminal strips to which the connections are made and has a
number of DIP switches to allow various parameters to be set for a particular application.
1.7.1 DIP SWITCH POSITIONS
Switch Position
1
2
3
4**
5**
6
running.
Increases speed or data values or scrolls up the Program parameters.
Decreases speed or data values or scrolls down the Program
parameters.
Changes display to either actual value of a parameter or parameter
name (used in Program Mode only)
Allows displayed value to be changed, either one count at a time
(LOW range) or 100 counts at a time (HI range) by the Up or Down
Arrow Key. In the Follower mode, the HI range changes the displayed
value by 10 counts at a time while running to allow for smaller
maximum incremental ratio changes.
Indicates that HI/LOW key input is in High mode.
Indicates that HI/LOW key input is in Low mode.
Indicates that display is actual speed of controlled motor or reference
input.
Indicates Program mode when LED is blinking
Indicates that display is the speed set-point.
Function
OFF – Setpoint Controller Mode
ON – Follower Mode
OFF – Enable PI and Position Control (Closed Loop Control)
ON – Disable PI Controller in Set Point Control Mode
(Scaled 0-10V for 0-1800 RPM)
ON – Disable Position Controller in Follower Mode*
Controlled Motor Feedback Type
OFF – Magnetic Pickup or Zero Cross Sensor
ON – Encoder or Open Collector (input impedance 3.3K)
Reference Motor Feedback Type
OFF – Magnetic or Zero Cross Sensor
ON – Encoder or Open Collector (input impedance 3.3K)
Tach Display Value (Enabled by Tach/Ref Key, applicable for follower
mode only)
OFF – Tach Shows Reference** RPM or Engineering Units
ON – Tach Shows Controlled Motors RPM or Engineering Units