Front Panel Controls - Seco DS9000 Installation & Operation Manual

Response
Display
Feed back
Sensor
Input Frequency
Range
Mode
Speed Range
Inputs
Outputs
1.5

FRONT PANEL CONTROLS

The DS9000 Front Panel has a 4-digit LED readout, 6 keypad controls, and 4 LED status indicators.
The keypad controls are:
PROG – Selects Program Mode, allows adjustment of:
TACH/REF
10 ms internal up-date time
4 digit, .6", RED L.E.D.
1) Magnetic pick-up (Seco MTK type)
2) Encoder
3) Open collector proximity switch
Master Mode
Max. Frequency 25KHz, Min. Frequency 30Hz
Follower Mode
Max. Frequency 20KHz, Min. Frequency 50Hz
Speed Set Point controller 0-1800 RPM
Follower – ratio adjustable 0-999.9% or equivalent.
35:1 with 60 ppr magnetic sensor on 1750 RPM motor
500:1 with 600 ppr Encoder on 1750 RPM motor
Feedback pulse train
Reference pulse train (Follower Mode only)
Start/Stop, 5-30V Isolated sink or source to Start
115V/230V AC 50/60 Hz 15VA
Security (prevents unauthorized parameter changes)
Speed/Ratio Parameter (selects one of four possible preset speeds or
ratios)
Parameter Data Table (selects one of two unique data tables, A or B)
Drives control signal 0-10V DC, (5mA max.), isolated from DS9000
common
Excessive following error indication for Follower Mode
+5VDC power supply for encoders (max current 40mA)
Operator Adjustments
4 Preset Speeds/Ratios
Minimum Speed
Maximum Speed
Acceleration Time
Deceleration Time
Set-Up Adjustments
Feedback resolution of controlled motor
Feedback resolution of reference signal (Follower Mode)
Readout Scale Factor and Decimal Point placement for
Controlled Motor
Readout Scale Factor and Decimal Point placement for
Reference Signal
Proportional Gain (Stability)
Integral Gain (Stability)
Position Error Gain (Follower Mode)
Selects display of either Tach signal or Reference Set-point while
5