Ds9000 Mounting; Ambient Temperature; Altitude; Fig. 2.1 Outline And Mounting Dimensions - Seco DS9000 Installation & Operation Manual

2.2.1

DS9000 MOUNTING

The DS9000 controller should be flange mounted to a panel in a horizontal position. Drill patterns
and dimensions for the DS9000 controller are shown in Figure 2-1. Be certain that the mounting area
provides the environmental conditions noted in the following paragraphs.
To mount the DS9000 in your panel, follow these steps:
1. Cut out the mounting hole for the DS9000 as shown in the panel cutout dimensions in Fig. 2.1.
2. Remove the two socket head screws in the back of the DS9000 with a 1/16" hex wrench.
3. Remove the two slides from each side of the DS9000.
4. Slide the DS9000 through the front of the panel cutout.
5. Replace the two slides on each side of the DS9000.
6. Replace and tighten the two socket head screws.
2.2.2

AMBIENT TEMPERATURE

Ambient temperature should not exceed 50°C for chassis mount unit.
2.2.3

ALTITUDE

Altitude should not exceed 1000 meters (3300 feet). Consult factory for de-rating factor for high
altitude operation.
12
Fig. 2.1
Outline and Mounting Dimensions