Generic A Larm ( Yellow-Green Wire); Summary Table Of Alarm Messages - Gemini 7892 MyMINI Installation And Use Manual

3.4 - GENERIC
Transmission of a generic alarm message is subject to connection of the
dedicated wire and system configuration by the installer.
When the message is sent, the system checks the alarm source. If still active, it
will be inhibited (i.e. door still open). If not active (i.e. door closed), it will be
restored to guarantee protection once again.

4.0 - SUMMARY TABLE OF ALARM MESSAGES

In case of a theft attempt, the system sends a text message to the user
indicating the type of alarm (see table below).
TYPE OF
ALARM
Position
(last stop)
Start
Power cut
Position
(PPC*)
Alarm
(AUX input=0)
* Periodic Position Control
Ignition detection, displacement (P.P.C.) and power cut-off alarms are subject
to tracker activation via SMS message or configuration of auxiliary input for
system arming via an external module.
The available configurations of the auxiliary input are detailed in par.
All text messages provide vehicle position coordinates, speed, date and time.
An "over speed alarm" can also be forwarded, to the 1st number only, when the
system is disarmed and ignition key is ON (par. 5.6).
ALARM (connection of
!
IGNITION KEY
ON OFF
ATTENTION
SYSTEM
STATUS
ARMED DISARMED
yellow-green wire)
PHONE
1st 2nd
number number
REF.
CHAPTER
3.1
3.2
3.3
5.10 and
8.0
3.4, 5.14
and 18.0
18.0 .