Using The Dcs-37-2 Mount (Optional) - D-Link DCS-4633EV User Manual

Section 2: Installation
To mount the camera with the DCS-37-2 mount, follow the instructions below.
Step 1
Place the DCS-37-2 mounting sticker in the desired location, then use a 6 mm
drill bit to drill the required holes 25 mm deep and insert the wall anchors into
the holes. If you plan to pass cables through the ceiling, you will also need to drill
a hole for the cable channel.
Note: The camera in the corresponding graphics may be different from your
product, but the procedure is the same.
Step 2
Use the provided screws to mount the DCS-37-2 to the wall using the inner
mounting holes.
Step 3
Guide the camera connectors through the back or side cable channel on the
DCS-37-2. Use the provided screws to mount the camera to the DCS-37-2 using
the set of mounting holes marked B.
D-Link DCS-4633EV User Manual

Using the DCS-37-2 Mount (optional)

14