3Com 6200 Hardware And Software Users Manual page 29

Interface Connections and First Time Start-Up
3COM Security Switch 6200 Hardware and Software Users Guide
SNMP Communities
================
Community Address
middle 10.1.1.22
Add the SNMP Communities <Y or N>[N]:
7. Configure the individual user accounts.
Accounts Configuration
=======================
This section allows you to change your "root" password.
Additionally, you can set up accounts for users to log
into once the Interview is complete.
Set 'root' Password <Y or N>[Y]:
Additional user accounts can be defined, each with its
own username and password.
Add or Modify User Accounts <Y or N>[Y]:
Enter User Name []:
Enter password:
Verify password:
Enable Login Access <disabled, enabled>[disabled]:
Enter Access Level <Guest, Network Operator, Service
Operator, Administrator>[Guest]:
The following is an example display showing configured users.
User Accounts
=============
User Name Login Access
admin enabled
foobar enabled
Add or Modify User Accounts <Y or N>[Y]: n
8. Configure the host interfaces.
Host Interfaces
===============
This section will help you configure interfaces on the
Host. The system has two management ports, two GigaBit
Ethernet ports, and 16 10/100 ports.
NOTE: At least one management port must be configured
on the system.
Netmask Access
255.255.255.255 read-write
Access Level
Administrator
Guest
3-11