Installing Valve Assembly - Regency F33 Owners & Installation Manual

MAINTENANCE
4) Disconnect gas line to stove.
5) Disconnect 3/8" NPT pipe from 90
6) Disconnect the two (2) switch wires from valve.
7) Remove two (2) orifi ce bracket screws inside fi rebox.
8) Remove thermodisc to bracket by removing three (3) phillips head
M5 screws.
9) Remove front cover with Piezo Igniter by removing two (2) sheet
metal screws.
10) Loosen four (4) phillips head M5 valve mounting screws from un-
derside of fi rebox. Push valve assembly forward on the teardrop
slots and drop down.
11) Disconnect Piezo wire.
Placement
of Decal
"Warning
240 Volts"
1) To install a new valve assembly, reverse instructions for removing valve.
See assembly steps 1-11.
2) Check for leaks and manifold pressure. See Gas Pressure Test instruc-
tions.
3) To reinstall valve, reverse instructions for removing valve assembly, steps
12-18.
18
o elbow on valve.
Front Cover Screws
Front of Stove
On/Off
Piezo
Ignitor
Gas Inlet
Valve
mounting screws
WARNING
3
240 Volts T-O-D 60711 T-O-D 60711
x
SA
L200-40F L200-40F
Thermodisc
Bracket
Thermodisc
VIEW FROM BOTTOM OF THE STOVE

INSTALLING VALVE ASSEMBLY

To remove valve from valve assembly, continue.
12) Remove two (2) thermopile wires.
13) Remove thermocouple with a 9 mm (metric) spanner.
14) Remove pilot nut with an 11 mm spanner.
15) Remove valve to orifi ce nut with a 13/16" spanner.
16) Remove inlet pipe with pipe spanner. Note orientation of 90
bow.
17) Remove two (2) phillips head M5 screws on each side of the
valve.
18) Remove valve and remove gas out 90
tion of fi tting.
Hi/Lo
313717 313717
1
9426 9426
T-O-D
Thermocouple
L200-40F L200-40F
T-O-D 9426 9426 SA
x
60711 60711 T-O-D T-O-D
1 3
313717 313717
nut
o
brass fi tting. Note orienta-
Thermopile
wires
Orifice
Thermocouple
wire
Gas Outlet
Regency ® F33-3 Freestanding Gas Stove
o el-
Orifice assembly
mounting screws