120 Vac Input Power Connection; Setting The: Limit Nuts & Open Left Or Open Right - Eagle AVI Installation & Owner's Manual

120 VAC Input Power Connection

Release Knob
Control
Board
Plate
Setting the: Limit Switches & Open Left or Open Right
CAUTION
Be sure that power is turned OFF.
Control
Board
Plate
Release
SELECT
SLAVE MASTER
OPEN LEFT OPEN RIGHT
BRAKE OFF BRAKE ON
CLOSE TIMER OFF CLOSE TIMER ON
OPENING CLOSING LIMIT
OFF—ON
FEATURE SELECTOR TIMER ERD CONTROL
S1 S2 FCN
0 1
ON ON STOP N/C
ON OFF CLOSE
RESET
M/S PHASE OFF ON PHANTOM
OFF OFF EDGE SENSOR
MULTI FUNCTION
ERD OVERLOAD
GND
#1
RCVR
24VAC
GND
#2 #3 #4 #5 #6 #7 #8
SLAVE MASTER
+ –
INPUT/OUTPUT
12
Black wire to Black wire.
White wire to White wire.
Green wire to Green wire.
Removing Release Knob will
allow control board plate to be
rotated up and gain easier
access to limit box, see above.
The limit nuts MUST be set so the
Knob
gate stops at the correct open and close
positions. the control board MUST have power
for the limit LEDs when setting the limit nuts.
Adjust the close limit nut FIRST when the gate
is in the closed position.
OPEN OPENING CLOSING CLOSED
LIMIT
GATE STATUS
OPEN LEFT
#9
+ –
COMM PORT COMM PORT POWER
CAUTION
Be sure that the circuit breaker for the input power is turned OFF
before connecting the input power to the operator.
All operators MUST be properly grounded.
Installing surge protection is recommended.
WARNING: Eagle Access Control Systems, Inc. is not responsible for
researching and complying with local building codes. Be sure to check
all local building codes before installation.
Wire Color Description
120 VAC
Black - 120 VAC input power
White - Neutral input
Green - Ground input
(from an approved grounding method)
120 VAC Input Power Wire
14 AWG 12 AWG
Single Operator
250 ft 400 ft
Dual Operators
125 ft 200 ft
IMPORTANT: DO NOT cycle the operator before
setting the limit nuts. Damage or injury could occur
if limit nuts are NOT set correctly. (See below)
SELECT
SLAVE MASTER
OPEN LEFT OPEN RIGHT
BRAKE OFF BRAKE ON
CLOSE TIMER OFF CLOSE TIMER ON
OFF—ON
FEATURE SELECTOR
OPEN OPEN OPEN OPEN OPEN OPEN OPEN OPEN OPEN OPEN OPENING CLOSING CLOSE CLOSE CLOSE CLOS CLOSE CLOSE CLOSE CLOSE CLOSE LOS
LIMIT LIMIT
GATE STATUS
Limit Limit
Nut LED Nut LED
Indicates the direction
the gate is cycling.
10 AWG 8 AWG 4 AWG
650 ft 1000 ft 2000 ft
325 ft 500 ft 1000 ft
Limit Nut
Limit Nut
L o
c k i
n g
T a b
To Set the Limit Nuts:
With power turned ON, press and
hold spring loaded locking tab
and rotate limit nuts accordingly
until LEDs light. Make sure nuts
are locked in position after
releasing locking tab.
OPEN RIGHT
AVI Slide Rev - C