Reverse And Exit In-Ground Loop Installation; External Entrapment Protection - Eagle AVI Installation & Owner's Manual

Reverse and Exit In-Ground Loop Installation

Reversing loops are used to prevent the gate from closing on a vehicle while it is in the gates path.
A exit loop is used to automatically open the gate when a vehicle approaches to exit.
A phantom loop is NOT used for slide gates.
An experienced installer should perform this installation.
Sealant
Backer Rod 1 1/2"
1/4"
Cutaway of Groove
Loop wire must be wrapped inside
the groove three times. Fill the
grooves with a proper sealant.
p a r
S e
w e
P o

External Entrapment Protection

Installation of a reversing edge(s) or photocells for the OPENING direction of the gate is recommended.
Mount reversing edge(s) where needed (end of gate along entire height of gate and/or next to opening on operator side).
Mount photocells for entrapment protection during the OPENING cycle of gate if needed as shown below (they are typically mounted 21"
above the ground but no higher that 27.5" high).
Multiple external entrapment devices may be connected in parallel to #4 M-FCN Input. Multi-Function switches 1 and 2 MUST be set to OFF.
#2 #3 #4
INPUT/OUTPUT
T r a
n s m
i t t e
r
R e
c e i
v e r
S e
p a r
a t e
P o
w e
r
Closing Direction
Photocells
10
Twisted
Loop Wire
Inside
PVC Conduit
Loop Feed
Loop feed must have the loop
wires twisted in them approx.
6 twists per foot.
a t e
External Loop Detector
r
Connect loop wires directly to external loop detector.
See page 16 to wire loop detectors to control board.
Multi-Function switches
#5 #6 #7
OFF
OPENING Direction Photocells
Miller
Reversing Edge
r
i t t e
n s m
T r a
v e r
c e i
R e
a t e
p a r
S e
r
w e
P o
Opening Direction
Photocells
4'
4'
Loop
Feed
S1 S2 FCN
ON ON STOP N/C
ON OFF CLOSE
OFF ON PHANTOM
OFF OFF EDGE SENSOR
MULTI FUNCTION
OPENING
Direction
Edge
Reverse Loop
4' 4'
4'
4'
Reverse Loop
4' 4'
4' Min.
Exit Loop
SELECT
SLAVE MASTER
OPEN LEFT OPEN RIGHT
OPEN OPENING CLOSING CLOSED
BRAKE OFF BRAKE ON
CLOSE TIMER OFF CLOSE TIMER ON LIMIT LIMIT
OFF—ON OPENING CLOSING
FEATURE SELECTOR TIMER ERD CONTROL GATE STATUS
S1 S2 FCN
0 1 ON ON STOP N/C
ON OFF CLOSE
OFF ON PHANTOM
OFF OFF EDGE SENSOR
MULTI FUNCTION
#1
#2 #3 #4 #5 #6 #7 #8 #9
SLAVE MASTER
+ – + –
INPUT/OUTPUT COMM PORT COMM PORT POWER
CLOSING Direction Photocells
OPENING Direction Edge
CLOSED Gate
Groove
CLOSING
Direction
Edge
AVI Slide Rev - C