Connecting The Power / Reverse / Exit Loop Installations - Eagle II Installation Manual

Be sure that the circuit breaker for the line input power is turned off before connecting the input power to the unit.
Connect 120 VAC, 15A, 60HZ, line input power
to the wires provided in the power switch junction
box located near the bottom of the operator .
Warning: Eagle Access Control Systems, Inc.
is not responsible for researching and complying
with local building codes. Be sure to check
these codes before installation.
Black - 120 VAC / Line Input Power
White - Neutral Input
Green - Ground Input (from an approved grounding method)
14 AWG
250 ft.
The Purpose for a reversing loop is to prevent the gate from closing on a vehicle while it is exiting or stopped
in the middle of the gate area. The purpose of the exit loop is to automatically open the gate when a vehicle
approaches to exit.
REVERSE LOOP
EXIT LOOP
IN
Eagle Access Control Systems, Inc. / (800) 708-8848 / www.eagleoperators.com
EAGLE-II Swing Gate Operator
____________________
Connecting The Power
CAUTION!
!
All units must be properly grounded
The wires are color coded as follows:
SUGGESTED WIRE
12 AWG 10 AWG
400 ft. 650 ft.
____________________
Reverse / Exit Loop Installation
Exit Loop Operation
OUT
REVERSE LOOP
PHANTOM LOOP
PROPER SEALER SHOULD
BE USED IN LOOP CUTS
(9)
!
8 AWG
1000 ft.
LOOP CUT
TWISTED WIRES
WIRE LAYERS
IN LOOP CUT
4 AWG
2000 ft.
Wires must be
wrapped inside
the groove three
times. Once you
have completed
the process, fill
up the grooves
with a proper
sealant.