F Irmware U Pdate - Globalstar Sat-Fi 2 User Manual

Firmware Update
Perform the following steps to update the firmware on your Sat-Fi2:
For Android:
1. Select in the top right corner
2. Select "App Settings"
3. Scroll down to "Check for New Firmware"
4. Select Download
5. Select "Start Download"
6. There will be two options available: "Start Update" or Run Update Later."
"Start Update" will begin the firmware update. If "Update Later" is selected, then the option
to reconnect to the Sat-Fi2 Wi-Fi will be available, then a green bar will be displayed. Select
it at any time and continue to Step 7.
7. Wait for the firmware to upload to the Sat-Fi2. After the firmware is uploaded, the Sat-Fi2
will reboot showing, so the LEDs will begin their scrolling sequence.
(NOTE: When the user reconnects to the Sat-Fi2 via the app, there will be a notification telling
the user that "The Sat-Fi2 was previously shutdown to complete a Firmware Update."
Globalstar Sat-Fi2 User Guide
For iPhone:
1. Select Settings icon on the main menu
2. Select Firmware Update, then the following message will be displayed: "Fetching currently running
Sat-Fi2 firmware version"
3. Select Download Update once the following message appears: "A message then will show saying a
New Update is available"
4. Select OK when the Sat-Fi2 App displays a message asking to disconnect from the Sat-Fi2 before
downloading the update
5. Select OK when prompt to connect to a broadband Wi-Fi connection to download the firmware
update or allow download over cellular in the Settings menu
6. On Settings enable Allow FW Download Over Cellular if no Wi-Fi connections are available
7. Select Firmware Update in order to begin the download
8. After the update has been downloaded, connect to the Sat-Fi2 and press Update Sat-Fi2 to continue.
While the Sat-Fi2 is updating, please do not close the app
9. The Sat-Fi2 will reboot, so the LEDs will begin their scrolling sequence and disconnects the phone
from its Wi-Fi. This indicates that the Sat-Fi2 updated
10. Updating Sat-Fi2 firmware update
(NOTE: When the user reconnects to the Sat-Fi2 via the app, there will be a notification telling the user
that the firmware was downloaded successfully. If it was interrupted or did not download successfully,
then the app will give a notification saying the firmware update was interrupted
Page 32