Select And Start A Washing Programme - Electrolux ESL 63010 User Manual

12 electrolux
2. Set the rinse aid dosage to position 2.
If you decide to turn back to the use of
standard detergent system we advise
that you:
1. Fill up the dispensers for salt and rinse aid
again.
2. Adjust the water hardness setting to the
highest setting and perform 1 normal

Select and start a washing programme

Select the washing programme with
the door slightly opened. The start of
the programme will occur only after
the closure of the door. Until then it
is possible to modify the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the on/off button. The appliance
must be in setting mode.
4. Press the programme selection/cancel
button until the light corresponding to the
required washing programme comes on
(see 'Washing programmes' chart).
Close the appliance door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
The start of the washing programme will
be delayed by 3 hours.
1. Select a washing programme.
2. Press the delay start button. The corre-
sponding indicator light comes on.
3. Close the appliance door. The count-
down starts automatically.
Opening the door will interrupt the
countdown. Once the door is closed the
countdown will continue from the point
at which it was interrupted.
4. Once the countdown has elapsed the
washing programme will start automati-
cally.
Cancel a delay start in progress
1. Open the appliance door.
2. Press the delay start button. The corre-
sponding indicator light goes off.
3. Close the door. The washing programme
will start automatically.
washing programme without loading any
dishes.
3. Adjust the water hardness setting ac-
cording to the hardness of the water in
your area.
4. Adjust the rinse aid dosage.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
Open the appliance door; the programme will
stop. Close the door; the programme will
start from the point at which it was interrup-
ted.
Cancel a washing programme in
progress
• Open the appliance door; press the pro-
gramme selection/cancel button for about
3 seconds, until the light of the running
programme goes off and the end of pro-
gramme indicator light flashes. The wash-
ing programme has been cancelled and
the appliance is now in setting mode.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The appliance will automatically stop and
an audible signal informs you of the end of
the washing programme.
• Open the appliance door.
• The end of programme indicator light is on.
• The indicator light of the programme just
ended remains on.
1. Switch off the appliance by pressing the
on/off button.
2. Leave the appliance door ajar and wait a
few minutes before removing the dishes;
in this way they will be cooler and the dry-
ing will be improved.