Arris NVG599 Administrator's Handbook page 175

set system supplicant enable [ on | off ]
Turns on the 802.1x supplicant functionality. You must set the corresponding type field in the WAN link to
activate it:
NOS/142253966608 (top)>> set link name WAN supplicant
Default is on.
set system supplicant dest-broadcast [ off | on ]
Mostly useful for debugging. If this is set to on, the destination MAC address FF:FF:FF:FF:FF:FF is used when
the supplicant sends 802.lx packets. If this is off, the EAPOL-specific destination address of 01:80:C2:00:00:03 is
used. Default is off.
set system supplicant eap-tls-identity string
Sets the identity sent by the supplicant in response to an Identity request from an 802.1x authenticator.
set system supplicant server-cert-check [ on | off ]
If set to on, examines the certificate chain sent by an 802.1x authenticator for validation, and ensures that the
root cert of this chain is accepted by the CPE (is in its trust list). Default is on.
set system syslog enable [ on | off ]
Enables or disables the NVG599 Syslog function. The Syslog function is disabled by default. If Syslog is enabled,
the following additional Syslog settings may be configured:
set system syslog server-ip <IPv4/IPv6 Address>
set system syslog server-port <port>
set system syslog facility [ local0 ... local7 ]
set system syslog level [ 0 ... 7 ]
set system syslog log-system [ on | off ]
set system syslog log-firewall [ on | off ]
set system syslog log-igmp [ on | off ]
set system syslog log-voice [ on | off ]
You must specify the Syslog server's IP address and any custom UDP port number to identify system logging
messages with the set system syslog server-ip <IPv4/IPv6 Address>
commands. After the Syslog server is specified, you may turn on any or all of the logging categories.
The receiving server must have a properly configured Syslog server package active.
set system syslog server-ip <IPv4/IPv6 Address>
Specifies the IP address (in IPv4 dotted decimal notation or IPv6 colon-separated hexadecimal notation) of the
server that Syslog messages will be sent to.
set system syslog server-port <port>
Customizes the UDP port number that the Syslog function marks messages to the logging server package with
(range: 1 - 65535, default: 514).
supplicant
type (none) [ none | eap-tls ]:
priority (0) [ 0 - 7 ]:
and set system syslog server-port <port>
175