Table of Contents
Advertisement
Paper Specifications
Paper Width
Paper Length
Paper Thickness
Copies
Copy Offset
Binding
Print Position
Print Area
Top margin
Bottom margin
Right margin:
Paper Feed
Drive
Pitch
Speed (while printing)
Speed (while ejecting)
Important!
Slip paper must be flat, smooth, and free of curls, bends, wrinkles and folds, all
of which can cause jamming and soiling by ink.
80 to 182mm / 3.15" to 7.17"
80 to 257mm / 3.15" to 10.8"
1-ply: 0.09 to 0.2mm / 0.0035" to 0.0079"
Total Thickness: 0.12 to 0.25mm / 0.0047" to 0.0010"
Original + 2
1.5mm maximum/15 lines (between top sheet and bottom sheet)
Top or left
Do not use paper with perforations within the shaded area. Perforations may cause the
paper sensor to erroneously report an out of paper condition.
28.6mm (When top of form sensor is set at a 26.5mm. Top of form detection can be
enabled and disabled using memory switch. When disabled, a command can be used to
reverse feed paper and start printing 20mm from top of paper.)
38.1mm (13.5mm or 14.0mm when bottom of form sensor is disabled.)
5.1mm
Stepping motor
Star Mode: Adjustable in 1/144" units
ESC/POS Mode: Adjustable in 1/60" units (approximate)
3.5" per second
4.5" per second
8 mm
No holes in this area
100
Advertisement
Table of Contents
