Advertisement
Regency P33 Sunrise Gas Fireplace
Venting Arrangements - Horizontal
Terminations
This lightly shaded area of the diagram shows allowable combinations of
vertical runs with horizontal terminations, using one 45° and one 90° elbow
(two 45º elbows equal one 90° elbow).
Note: Must use optional rigid pipe adapter (Part # 510-994) when using
Rigid Pipe.
•
Maintain clearances to combustibles.
•
Horizontal vent must be supported every 3 feet.
•
Firestops are required at each fl oor level and whenever passing through
a wall.
A vent guard may be required as per local codes, refer to Exterior Vent
Termination Locations.
Note: FPI Direct Vent System (Flex) is only approved for horizontal
terminations.
Horizontal (Feet)
0
2
4
16
14
12
10
8
6
4
30" (762mm)
- Rigid
2
Minimum
Note: Height measured from the base of the unit.
Height
Requirement
0
26" (660mm) - Flex
8"(0.2m)
2' (0.6m)
36
34
32
30
28
26
24
22
20
18
16
6
8
10
12
14
16
14
12
10
8
6
4
2
0
30
28
26
Venting Arrangements - Vertical
24
Terminations
Rigid Pipe System
22
(Propane & Natural Gas)
The P33 is approved for a maximum 40 ft. straight vertical, with Rigid
20
Pipe vent systems for Propane and Natural Gas.
The lightly shaded area,
18
confi gurations with a maximum two 45° elbows.
The darker shaded area,
16
confi gurations using one 45° and one 90° elbow.
•
Vent must be supported at offsets.
•
Horizontal sections must be supported every 3 feet.
14
•
Firestops are required at each floor level and whenever
passing through a wall.
12
•
Maintain clearances to combustible materials.
•
Minimum of 1' pipe section between elbows.
10
Note: Must use optional rigid pipe adapter when using Rigid Pipe
(Part # 510-994).
18
20
8
6
40
4
38
36
2
34
0
32
30
28
26
24
22
20
18
16
14
12
10
8
6
4
2
0
Minimum 12" (305mm)
Note: Height measured from the base of the unit.
P33 Sunrise Gas Fireplace
, in the diagram shows allowable venting
, in the diagram shows allowable venting
0
2
4
6
8
10
Max. 10' (3m)(centerline to centerline)
18
12
14
16 16
20
Advertisement
