Add & Delete Z-Wave Devices - DSC PowerSeries PC1616 Installation Manual

ADD & DELETE Z-WAVE DEVICES
Please visit the Dealer Website Support Resources for a complete
explanation of Z-Wave communication, Z-Wave signal strength,
and additional installation resources.
Alarm.com will not recognize any Z-Wave devices previously learned into
the panel. These devices will need to be deleted from the previous Z-Wave
network and added to the SEM for the customer to use Alarm.com's home
automation services (e.g. automation control via customer website, app,
and intelligent automation rules).
If the customer is on a different interactive platform,
TIP:
we recommend having them log in to that site and taking
screenshots of notifications, rules, and home automation
device names for reference later.
For optimal Z-Wave signal strength, make sure the orange Z-Wave
antenna is pointed down toward the tabs at the base of the SEM.
ADDING Z-WAVE DEVICES
Using the Dealer Website or MobileTech is strongly recommended.
Using MobileTech
1. Move all Z-Wave devices to their final location on the property.
2. Open MobileTech and select the customer.
3. Navigate to the Equipment List screen.
4. Select emPower Management.
5. Select Add Z-Wave Devices.
6. Wait for the bolded message: Checking for new devices on
the network.
7. Trigger a device to add it to the network.
8. When a device is added successfully, it will show up on
this screen following a 30 second delay.
9. Continue triggering devices. You may add several devices
to the network without re-entering Add Mode.
10
Z-Wave
Button
Z-Wave
Antenna