Panasonic Toughbook CF-07 Series Reference Manual page 34

Setup Utility
Boot Menu
Exit Menu
Parameters
Save Values & Exit
Exit Without Saving Changes
Get Default Values*
Load Previous Values
Save Current Values
* This item may not be displayed when starting up the Setup Utility with the User Password.
<Only when the port replicator is connected>
Floppy Drive
Hard Disk Drive
CD Drive
LAN
The default order is as follows:
[Floppy Drive] [Hard Disk Drive]
To move a device up by one in the order, select the device with
F6 .
To move a device down by one in the order, select the device with
F5 .
NOTE
Boot First Menu
The device for starting up the Operating System can also be selected during computer
start-up.
After the computer is turned on, the device selection display will appear when ESC is
pressed while "Press <ESC> to enter Boot First Menu" is shown. (When selecting [CD
Drive] from Boot First Menu, if the CD has not been set in the CD-ROM drive, it is not
possible to start up from the CD.)
When the setting of the [Boot] menu is changed, the selection screen display will also
change. ( "Starting Up/Shutting down")
Save Values & Exit
Exit Without Saving Changes
Get Default Values
Load Previous Values
Save Current Values
Exit the Setup Utility and save your changes to CMOS.
Exit the Setup Utility without saving your changes to CMOS.
Set the default settings.
Load previous values from CMOS for all Setup items.
Save your changes to CMOS.
[CD Drive] [LAN].
34
and ,and then press
and ,and then press