Lan - Panasonic Toughbook CF-07 Series Reference Manual

LAN

<Only when the port replicator is connected>
Using LAN
LAN port
When using the LAN, set [LAN] to [Enable]* in the Setup Utility. (* Default)
1
Power off your computer
Do not shut down using the standby or hibernation mode.
2
Connect your computer to the optional port replicator
( Operating Instructions of the port replicator,
3
Connect the LAN cable to the port replicator
Setting LAN
Windows 98
1
Select [Device Manager] in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager].
2
Select [Intel(R) PRO/100 VE Desktop Adapter], then select [Properties].
3
Remove a check mark [Disable in this hardware profile], select [OK], then select
[Close].
4
Restart the computer.
NOTE
Do not use standby or hibernation functions during communications.
Unable to connect to network (When the indicator of your HUB unit does not light):
Windows 98
1 Select [Network] in [Start] - [Settings] - [Control Panel].
2 Select [Intel(R) PRO/100 VE Desktop Adapter].
3 Select [Properties].
4 Select [Advanced].
5 Select [Link Speed & Duplex] from [Property], set [Value] to the communica-
tion speed (10 Mbps or 100 Mbps) suitable for your network environment, then
select [OK].
Windows 2000
1 Select [Device Manager] in [Start] - [Settings] - [Control Panel] - [System] -
[Hardware].
2 Select [Intel(R) PRO/100 VE Desktop Adapter] from [Network adapters].
3 Select [Action] - [Properties].
4 Select [Advanced].
5 Select [Link Speed & Duplex] from [Property], set [Value] to the communica-
tion speed (10 Mbps or 100 Mbps) suitable for your HUB unit, then select [OK].
Using the computer as a network computer
When using the computer as a network computer, some additional settings may have to
be made depending on the usage conditions. We recommend asking your system ad-
ministrator or the person in charge of the network.
( "Starting Up/Shutting Down")
page
27
23)