Panasonic Toughbook CF-07 Series Reference Manual page 28

LAN
<Only when the port replicator is connected>
Wake up from LAN
This is a function to automatically power the computer on from a network server when
the computer is in the standby or hibernation mode*. To use this function, it is neces-
sary to have a network environment that accommodates Wake up from LAN.
To use this function:
1 Select [Device Manager]*
2 Select [Intel(R) PRO/100 VE Desktop Adapter] from [Network adapters].
3 Select [Properties]* .
2
4 Select [Power Management], add the check mark for [Allow this device to bring the
computer out of standby.] and [Allow the computer to turn off this device to save
power.], then select [OK].
Windows 2000
* 1 : [Hardware] - [Device Manager]
Windows 2000
* 2 : [Action] - [Properties]
NOTE
Be sure to connect the AC adaptor, and enable the supply of power.
Make settings to allow the use of a Local Area Network.
The computer will not "wake up" if the LAN cable is disconnected and recon-
nected.
When using the Wake up from LAN function, remove the check mark for [Prompt
for password when computer goes off standby] in [Start] - [Settings] - [Control
Panel] - [Power Management]* - [Advanced].
* Windows 2000 : [Power Options]
The Wake up from LAN function will not operate when the computer has been
shut down.
This works irrespective of the [Wake up from LAN] setting of the Setup Utility.
in [Start] - [Settings] - [Control Panel] - [System].
1
28