• The Saltwater System requires a separate filter pump [700~4000 gph
(2650~15140 lph)] to drive the water and function properly.
• The Saltwater System must be installed as the last piece of pool
equipment in the water return line to the pool as displayed in Drawing
#1. This location extends the life of the titanium plates.
1. Assemble the above-ground-pool (AGP) and its filter pump according to their
installation instructions.
2. Take the Saltwater System and its accessories out of the packaging.
3. Place the Saltwater System in line after the filter pump.
4. Connect the connector hose (8) to the Saltwater System inlet.
Connecting the system to pump and pool with 1-1/4" (32mm)
connections/hoses:
The saltwater system features 1-1/2" (38mm) connections. It is accordingly
supplied with adaptors A (1) and B (9) for connecting to the small 1-1/4"
(32mm) diameter connections/hoses. Install as follows:
Drawing #1
WATER TO
POOL
ID 1-1/4" (32mm)
HOSE
1
SAVE THESE INSTRUCTIONS
(131) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5" X 10.3" PANTONE 295U
SETUP INSTRUCTIONS
IMPORTANT
SWIMMING POOL
BOOST
SALTWATER
SYSTEM
9
English
WATER FROM
POOL
ID 1-1/4"
(32mm) HOSE
FILTER
PUMP
8
9
Page 8
07/28/2010
131
Need help?
Do you have a question about the CS8110 and is the answer not in the manual?