Vimtag P1 User Manual page 17

VIMTAG SURVEILLANCE SOLUTION USER GUIDE
VimBox is considered to be a device and each must be added one time to
create an overall surveillance system.
To add a device using a mobile device:
Note: For adding a device on a computer, see the following section.
1. Log into the Vimtag app and on the main page, click + to add a
device.
Note: You only need to add a device once. After that, the device will
appear in the account, regardless of whether you access the account on
an iOS device, an Android device or a computer.
2. A QR scanner program will open. Locate the QR code on the bottom
of the device and let the mobile device scan the QR code.
Alternatively, you can click Manual input device ID and then enter
the device ID manually. This includes entering the 13 character device
ID found on the bottom on the device and the initial password of the
device. The default password for all devices is admin (all lower case).
3. Press Add.
4. On a mobile device, select Wi-Fi. Your Wi-Fi name should appear.
Enter your Wi-Fi password and press Add. Alternatively, you can use
a wired connection via the Ethernet port. For the EagleCam (P1) and
PearlCam (M1), an Ethernet adaptor can be found in the original box
in which the device was shipped.
5. Within 90 seconds, the device should be connected to the Wi-Fi and
you will be directed to change the device password. The new
password should be 6-20 characters and IS case sensitive. When the
system has finished configuring the device, you will see a Finish
prompt. Click OK.
Note: If, after following the procedure detailed below on a mobile
device, the system failed to connect with the smart Wi-Fi, check the
following:

That your wireless network is turned on and active
Page
16