Adding A Device - Vimtag P1 User Manual

VIMTAG SURVEILLANCE SOLUTION USER GUIDE
Vimtag site and add the device using the Add a device option (+ on
mobile devices), to get it started.
Wi-Fi: If you plan to connect through Wi-Fi, you will find the camera on
the network with a mobile device once it is hooked up and the power is
turned on. You will be able to add the camera, using the Add a device
option, on the Vimtag app.
Note: If connecting the VimBox, there is no Wi-Fi connection option and
therefore the device must be manually connected using an Ethernet
connection.
To connect your device to your network:
1. Connect the device to a power source and wait approximately one
minute for the camera to fully power On. If you connect via an
Ethernet connection, the wired network light will flash green three
times every three seconds, indicating that the camera is connected
normally.
2. Connect your mobile device to the same Wi-Fi on which the device is
running.
Note: This only needs to be done once during the initial setup.
After you connect your device to the network, you need to log in to your
Vimtag account and add the device to it.
For more information, see:

Logging in to the Vimtag Account


Adding a Device

Adding a Device
Once you have created an account and connected the devices to your
network, you can now add the device to your account. Each camera or
Page
15