Stitch Length; Cleaning The Machine - KANSAI SPECIAL RX9701J Series Instructions Manual

4 4 4 4 - - - - 3 3 3 3 Stitch length

Stitch length Stitch length Stitch length
The stitch length is adjustable from 1.4~4.5mm. The following table shows the number
of stitches within 1 inch (25.4mm) according to the stitch length.
Stitch length
4.5mm
4.0mm
3.0mm
2.0mm
1.0mm
■To change the stitch length
Turn adjusting knob A or position lever B as required.
The readings show the stitch length.
< Note >
When turning adjusting knob A or positioning lever B,
loosen screw C. Since this machine has a single feeding
system, differential feed is unavailable. To change the
stitch length, be sure to turn off the power.
■On the RX9701J Series, the feeding amount can be
changed mechanically up to 4.5mm.
To achieve a feeding amount of 4.5mm, loosen screw F
on the adjusting knob and release the stop position by
moving stop pin G. Adjust while checking the front or
back clearance so that the needle plate will not touch
the feed dog.
【5】CLEANING THE MACHINE
At the end of each day, remove the needle plate
and clean the slots of the needle plate and the
area around the feed dogs.
No. of stitches
(within 1")
5.5
6.5
8
12
18
7