Kaden KS09 Installation Manual page 24

WARNING
Before performing any electrical or wiring work, turn
off the main power to the system.
1. Prepare the cable for connection:
Use the right cable
• Indoor Power Cable (if applicable): H05VV-F
or H05V2V2-F
• Outdoor Power Cable: H07RN-F
• Signal Cable: H07RN-F
Minimum cross-sectional area
of power and signal cables
Rated Current of
Appliance (A)
> 3 and ≤ 6
> 6 and ≤ 10
> 10 and ≤ 16
> 16 and ≤ 25
> 25 and ≤ 32
> 32 and ≤ 40
a. Using wire strippers, strip the insulation from both ends of
cable to reveal about 40mm (1.57in) of the wires inside.
b. Strip the insulation from the ends of the wires.
c. Using a wire crimper, crimp u-lugs on the
ends of the wires.
24 | Kaden Installation Manual
J3387_Kaden_Installer_Manual_050917.indd 24
Nominal Cross-Sectional
Area (mm²)
0.75
1
1.5
2.5
4
6
Pay attention to live wire
While crimping wires, make sure you clearly distinguish the
Live ("L") Wire from other wires.
WARNING
All wiring must performed strictly in accordance with
the wiring diagram located inside the outdoor unit's
terminal cover and to local and national requirements.
2. Unscrew the electrical terminal cover and remove it.
3. Unscrew the cable clamp below the terminal block and
place it to the side.
4. Match the wire colors/labels with the labels on the terminal
block, and firmly screw the u-lug of each wire to its
corresponding terminal.
5. After checking to make sure every connection is secure,
loop the wires around to prevent rain water from flowing into
the terminal.
6. Using the cable clamp, fasten the cable to the unit.
Screw the cable clamp down tightly.
7. Insulate unused wires with PVC electrical tape. Arrange
them so that they do not touch any electrical or metal parts.
8. Replace the wire cover on the side of the unit, and
screw it in place.
Cover
Outdoor Unit Wiring Diagram
is located on the inside of the
wire cover on the outdoor unit.
Fig. 4.6
5/09/2017 9:08 AM