Adding A Further Transponder To A Memory Plan Currently In Use; Deleting A Memory Plan - Rover Instruments MASTER STC User Manual

•
Highlight the memory plan position item (PR...) and select the transponder to be
replaced.
•
Highlight the signal type (analogue, digital DVB-S and DSS) item displayed on the
LCD second row and select the required signal type.
•
Highlight the LNB high/low band and polarization, DISEqC, Local oscillator (L.O.)
and Symbol rate (SR) items. Select the required value for each item.
•
Highlight the frequency value displayed on the LCD top right corner, and select the
required value. Rotate the encoder [D] quickly to speed up the surfing of the desired
frequency value.
•
Highlight the item STORE? or the item OVERWRITE? to replace the transponder,
and press the encoder knob [D] .
The selected transponder will be stored in the current target memory plan.
To add and/or replace further channels to the memory plan, highlight the memory
position item (PRxxx) on the display top row and proceed as above described.
Press once and release the MEAS [5] key to quit this menu.
22.2 ADDING A FURTHER TRANSPONDER TO A MEMORY PLAN
CURRENTLY IN USE
Refer to Chapter 18.2 MANUALLY TUNING THE TRANSPONDER at page 57 to tune the
transponder.
•
Press and hold for 2'' the MANUMEMORY [9] key.
•
The transponder will be automatically stored in the first void position of the current
target memory plan. The LCD will display:
Press once and release the MEAS [5] key to quit the menu.

22.3 DELETING A MEMORY PLAN

THE MEMORY PLAN CURRENTLY USED CANNOT BE DELETED. THE SATELLITE
MEMORY PLANS PROGRAMMED EX FACTORY (EUTE70, PANS68, ...), CANNOT BE
To modify the memory plan currently in use, refer to the Chapter 18 METER
CONFIGURATION : PLAN at page 56.
MASTER STC
USER MANUAL
DELETED.
69