Manual Signal Standard Selection - Rover Instruments MASTER STC User Manual

any frequency band by simply surfing the selected frequency band or by simply adjusting the
frequency value to be tuned; from time to time and with no action by the user required the
meter will detect the proper standard for the received signal, and will set the meter
accordingly to it, together with the appropriate measurements set.
Under rare and very critical conditions (like a co-channel interference caused on a DVB-T
signal by an analogue TV signal receivable on the same channel and with a comparable
signal strength), the Rover Autodiscovery system could set the meter to manage the
analogue signal (the interfering one) instead of the digital one.
In these conditions it is possibile to manually select the signal standard and the relevant
measurements set.

MANUAL SIGNAL STANDARD SELECTION

Select a User Defined (MANU) Memory Plan, as described at Chapter 10.2 "NAVIGATE
INTO THE CHANNEL PLAN (USER DEFINED CHANNEL PLAN)" at page 20. Using the
Standard Navigation Mode tune the desired channel or the desired frequency value.
From the channel power (or signal level) measurement screen, using the Standard
Navigation Mode, highlight the signal standard (TV ANALOG / TV COFDM DVB-T/H /
...) and select the requested one. Then press the encoder [D] knob to enter your
selection.
Press once and release the MEAS
18
MASTER STC
USER MANUAL
[5] key to quit the menu.