Table of Contents
Advertisement
Firebrick installation
Side's firebrick installation
Put 4 bricks « A » and 2 bricks « B » as shown.
Back's firebrick installation
Put 2 bricks « A » and 1 brick « C » in the back and place the 2
bricks «H» on top. Screw in the triangular firebrick retainer ( I )
Floor's firebrick installation
Put 2 bricks « A », 2 bricks « H », 1 brick « I », 1 brick « G » as
shown in the image below.
July 13, 2017
Firebrick installation on the pipes
The firebricks must be put on the 5 pipes on the front of
combustion chamber. Bricks keep the maximum heat inside the
combustion chamber and help the air from the tube burn the most
of the gas from wood which wouldn't be burnt in any other
manner.
The rockwool above the brick prevents leakage between the
bricks and keeps a maximum heat inside combustion chamber.
It must cover up all the bricks and the air corridors of both sides.
IMPORTANT: The rockwool must not obstruct the smoke path.
Check the rockwool by removing the left top lid hole in the hob
and make sure that it is in a good position. Place the two half-
round steel plate on the rockwool as illustrated.
From the hole in the hob, put 2 bricks « A » and 1 brick
1.
« C », over the whole length of 3 the pipes in the back.
Push the bricks against the back bricks with a slight angle
as shown in the image.
Place 2 bricks « K » and 1 brick « J » over the whole length
2.
of the 3 pipes at the front in the same manner as step1
8
Advertisement
Table of Contents
