Table of Contents
Advertisement
Door maintenance
The door is the mobile element that needs a special attention.
Its tightness is essential. When the braided fiberglass rope is
worn out, you will see the white soot sticking on the glass
where the air leaks.
IT'S IMPORTANT TO KEEP ALL DOOR AND OPENING
•
CLOSED WHILE IN OPERATION.
IT'S IMPORTANT TO KEEP ALL GASKET TIGHT,
•
SEALED AND IN GOOD CONDITION.
Air tight Adjustment
If the braided fiberglass rope still seems in good condition but
little flattened, it needs probably to be tighten.
Door adjustment (right side)
The adjustment on the right side can be done with the screw
under the door near the hook hole.
1)
Unlock and open the door.
2)
With a square screwdriver, turn the adjustment screw
clockwise by a quarter turn.
3)
Put a piece of paper between the stove front and
fiberglass rope. Close and lock the door.
4)
If the paper slides easily when you pull it, repeat steps
1 to 3 again.
5)
If the screws are tightened completely but the piece of
paper comes off easily, the braided fiberglass rope
need probably to be changed.
Cleaning up glass
To clean the glass, J.A. Roby Inc. recommends using products
sold for this purpose or an oven cleaner. Take care not to
enter in contact with other stove surfaces than the glass when
using this kind of products.
Avoid cleaning the glass when it's hot or by using abrasives.
Cleaning the glass when it's hot can cause a thermal shock
which can break it.
Disassembly and reassembly of the door
To disassemble the door, keep the lower hinge tighten.
1) Open the door.
2) Unscrew the upper hinge nut (C) with a spanner
partially or completely so that you can liberate the
upper part of the door.
3) Remove the tilted door from the lower hinge by lifting
it
To reassemble the door:
1) Put the door on the bottom hinge and align the top
part of the door straight
2) Screw back the top hinge bolt assembly (A, B, C)
inside the door hinge as shown and make sure the left
side of the door is pressed evenly against the
appliance front wall before tightening the hinge bolt
definitely. check if the door is straight.
July 13, 2017
Replacing broken glass
To avoid braking the glass;
• DO NOT HIT THE GLASS,
• DO NOT SLAP THE DOOR,
• NEVER BUILD FIRE NEAR THE GLASS,
• NEVER PUT WATER ONTO THE GLASS TO AVOID A
THERMAL SHOCK,
• NEVER OPERATE THE STOVE WHEN THE GLASS IS
BROKEN OR CRACKED.
Replace only with a 4 mm ceramic glass with the right shape.
Contact your retailer to get a replacement glass.
DO NOT USE SUBTITUTE.
How to replace broken glass
1)
Loosen partially the screws retaining the four glass
supports.
2)
Remove all pieces of broken glass and clean the
door.
3)
There is a fiberglass rope around the glass to seal it.
If not, you need to install it without pulling it too much
so that the rope remains thick. The rope has a self-
adhesive side to stick onto the door glass.
4)
Install the new glass and put the lower support first
and gently tighten the screws. If the screws are
tighten too much, it will create pressure points and it
might break the glass when it gets hot. The fiberglass
rope will be pressed gently around the glass against
the door.
5)
Install the top support and gently tighten the screws.
6)
Verify if all the screws are tightened properly.
If you cannot replace the glass with the door in vertical
position, you may have to remove the door by following the
instructions of this manual.
25
Advertisement
Table of Contents
