RCA Product Manual page 8

Product Manual – INTUITION HT
SETTING/RESETTING THE ATTRACT LOOP
There are two configuration options for the attract loop. You
can set whether you want to password-protect the attract loop
(i.e., password is needed to initiate a session, thus requiring an
employee to walk the customer through the experience). You
can also set the inactivity timeout (i.e., the length of inactivity
time before the system switches back to the attract loop).
The system is shipped with no password protection on the
attract loop and the inactivity timeout is set for 3 minutes. If
you want to change these settings:
1. From the Manager Control Panel, touch Set/Reset Attract
Loop.
2. Select Set/Reset Password if you want to password-
protect the attract loop. Follow on-screen instructions to
create a password. The password you select only applies to
the attract loop and does not affect the manager mode
password.
3. Select Set/Reset Inactivity Timeout to change the timeout
settings. Select the desired timeout length. ( fig. 9 ) Select
No Timeout if you want to disable the timeout feature. The
system notifies that
ENABLING/DISABLING PRODUCTS
There may be times when you need to disable a product in the
display (e.g., product is temporarily unavailable because it has
been sold/removed from the display) and then later re-enable it.
To enable or disable products:
1. From the Manager Control Panel, touch Configure Positions.
2. Select a product category (e.g., A/V Receivers) from list on
the top.
3. Touch the component number you want to disable. When a
product is disabled, a red X appears instead of the product
number. ( fig. 10 ) Touch the number again when you want
to re-enable the product.
MODIFYING GOOD, BETTER, BEST
Use this option to modify the components that comprise the
pre-configured systems (i.e., Good, Better, and Best).
1. From the Manager Control Panel, touch the Modify Good,
Better, Best button.
2. Select package you want to modify (e.g., Best).
3. A new screen appears showing the current components for this system. ( fig. 11 ) To modify this system, select
the product category you want to modify from the list on the top (e.g., A/V Receivers).
4. Select a new component to add it to the package.
5. After you have made all selections, touch the Submit Change button.
8
the timeout has changed.
fig. 9 – Inactivity Timeout screen
fig. 10 – enable/disable product
fig. 11 – Modify Good, Better, Best screen